Installing HMS and Configuring a workstation to print in a physical printer
This content is restricted to registered users only. Please call IT department if you need to see this information.
This content is restricted to registered users only. Please call IT department if you need to see this information.
Printer Zebra or Labels Printers:
To start the printer
1-In command Enter wrkdevd (Printer name) Example: wrkdevd PSRXZeb1
• Select the device, and click the Work with status button
* Vary on
*OK
2-In Command Enter go main, select:
* 3-General System task, or type 3 and enter
* 1-Jobs, or type 1 and enter
* 4-Work with Printers, or type 4 and enter
3-instead of Select the printer, and click the Start button. Used the Command line, enter strrmtwtr and Printer name( strrmtwtr PSRXZEB1) and enter to finish
Nota: If you need stop the printer type endwtr psrxzeb1 *immed
Pharmacy Printer in MedHost
-After the normal steps.
-log out and log in
-Select Pharmacy Main Menu
-File Maintenance Menu1
-System Control File
-ok
-ok
-ok
-ok
-Output Queues:
Reports: PSBOPRT04 (A printer to print normally)
IV labels: PSRXZEB1 ( A label printer)
Unit dose labels: PSRXZEB2 ( A label printer)
MAR: PSBOPRT05 ( A printer to print normally)
-ok
-RX System Control File Maintenance
-Discharge Output Queues:
Reports: PSBOPRT04
IV labels: PSRXZEB1
Unit dose labels: PSRXZEB2
Take-Home Receipts: PSBOPRT05
-ok
-ok
-exit
There is other additional way to get to “work with Printer Status”
– Issue the command “GO MAIN”
– On this windows click on “General system Tasks”
– Click on “Status”
– Click on “Work with Printers”
– Once there, now you find the printer with the problem and review the status.
if the printer does not start, it is recommended first make a ping and see if it is online.